Hi there! Are you ready for our next Inspired by DIY challenge? Our featured store this time was Urban Outfitters and boy, was I amazed at what my friends came up with! You can find all 7 DIYs Inspired by Urban Outfitters below.
I’ve been working a lot with copper wiring lately and had an extra piece of a 40″ copper tube so I chose a really cool Urban Outfitters jewelry stand for my project.
Inspired by DIY: UO Jewelry Stand
Supplies for the Jewelry Stand:
Copper tube (thin enough to bend)
Hot glue gun
The first step is to mark the center of the copper tube with a piece of tape. Form an “S” shape by using a round object (like a pot or something else that is about 5 inches in diameter) and bend the copper around to form a half circle. Repeat on the other side of the middle going the opposite direction.
Use a ruler to bend each side up at a right angle. Trim off at 10 inches on each side with the wire cutters.
Use a rubber mallet to flatten the sides.
Cut the wooden dowel to 11 inches if needed (image top left). Use leftover copper tubing or heaving gauge wire (image top right) and cut two 1 1/2 inch pieces. Bend each piece around the wooden dowel to create a “u” shape (image bottom left).
Secure each “u” to the ends of the copper tubing with a dot of glue and coiling copper wire around the stand and over the “u” piece. (See bottom right image.) Trim off any excess wiring.
Store and display your jewelry by sliding it onto the dowel and place the dowel on the “u” shaped holders.
For some reason, my husband really liked the way this turned out. Maybe he can hang his watches from it….
Thanks for stopping by today!
You might also enjoy: